Vision Controls Cam SS Version 5.01 Instrukcja Obsługi Pobierz pdf (Strona 29)

Installing In-Sight

5000 Series Vision Sensors

3. Verify that the 24VDC supply is not receiving power, then connect the power supply to the

Breakout cable (

Figure 3-4). Attach the Breakout cable to the 24VDC connector on the

sensor.

Figure 3-4: Power Connections

NOTE:

Unused bare wires can be clipped short or tied back using a tie made from non-conductive

material. Keep all bare wires separated from the +24VDC (White/Green) wire.

CAUTION: Never connect voltages other than 24VDC. Always observe the polarity

shown.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 75 76

Brak uwag

Vision Controls Cam SS Version 5.01 Instrukcja Obsługi Strona 29